Pentax EI-200 Operating Manual page 71

[Logo Stamp] screen before set up
Screen with the stamp logo function being
[On]
2
Set the stamping format of the logo
1While the stamp logo function is [Off] and indicated in
highlighted text, press the right and left arrows of the
four-way controller, and the stamp text function [On] will
then be displayed in highlighted text.
2Press the left soft key to select [Edit] on the soft menu,
and a logo file screen appears.
3Press the upper and lower arrows of the four-way
controller to display a logo file to be stamped in
highlighted text.
4Press the left soft key to select [Select] on the soft
menu, and a check mark appears beside the file name.
5Press the right soft key to select [Exit] on the soft menu,
and the selected file name is displayed to indicate the
logo stamp.
6Press the lower arrow of the four-way controller to
display [Placement] in highlighted text.
7Press the right and left arrows of the four-way controller
to select the logo stamping position.
When you press the right arrow of the four-way
controller, the following stamping position options will
be displayed in this order:
[Upper right] / [Center] / [Lower Left] / [Lower
Right] / [Upper Left]
8Press the right soft key to select [Exit] on the soft menu,
and [Image Stamp] menu appears.
If you want to resume the initial state, press the left soft
key to select [Default] on the soft menu.
9Press the right soft key to select [Exit].
You can now stamp the logo on a picture according to
the settings.
Stamping Date & Time And Text On A Picture
69