Blower Installation - Quadra-Fire HUDBAY-FS Owner's Manual

H. Blower Installation
KIT CONTENTS: Blower; 2 female spade wire connectors.
TOOLS REQUIRED: Powered screwdriver with a #2 Phil-
lips head bit.
The blower motor comes standard with two male spade
wire connectors. If your appliance has a different con-
nection, use the two female spade wire connectors pro-
vided to modify the appliance wiring harness.
Disconnect power to the appliance. To access
Figure 8.20
the blower, open the door located on the front of the pedes-
tal. Remove the two screws holding the blower bracket in
place.
Fan Assembly
Figure 8.23 Blower Wiring Diagram
Page 32
Thermal Disk
F
F
BLK
F
M
BLK
Ground
BLK
Quadra-Fire • Hudson Bay • 7003-121 Rev. Q • 8/13
Disconnect wires to the blower motor. Remove
Figure 8.21
the blower from the bracket.
Figure 8.22
over studs on the blower bracket. Reinstall the blower and
bracket. Connect the wires. Install screws. Restore power
to the appliance.
WHT
M
F
GRN
M F
Strain Relief Bushing
Install the new blower by slipping grommets
Fan Speed Control
WHT
BLK
F = Female spade connector
M = Male spade connector
Power Cord (110 VAC)