9
Operating Instructions
A. Before Lighting Appliance
Read this entire manual prior to using the appliance. Failure
to follow the instructions may result in property damage,
bodily injury, or even death.
•
Remove all shipping materials from inside and/or
underneath the firebox.
•
Review proper placement of logs, mineral wool.
•
Check the wiring.
•
Check the baffle adjustment.
•
Ensure that there are no gas leaks.
•
Ensure that the glass is sealed and in the proper posi-
tion.
•
Ensure that the flow of combustion and ventilation air
is not obstructed (front grilles and vent caps).
WARNING
Glass door must be in place when appliance is
operating.
Risk of:
•
Combustion Fumes
•
Fire
Do NOT operate appliance with glass door
removed.
• Open viewing glass for servicing only.
• Glass door MUST be in place and sealed before
operating appliance.
• Only use glass door certified for use with appliance.
• Glass replacement should be done by qualified
technician.
WARNING
HOT SURFACES!
Glass and other surfaces are hot during
operation AND cool down.
Hot glass will cause burns.
• Do not touch glass until it is cooled
• NEVER allow children to touch glass
• Keep children away
• CAREFULLY SUPERVISE children in same room as
fireplace.
• Alert children and adults to hazards of high temperatures.
High temperatures may ignite clothing or other flammable
materials.
• Keep clothing, furniture, draperies and other flammable
materials away.
Page 34
Quadra-Fire • Hudson Bay • 7003-121 Rev. Q • 8/13
WARNING
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage. Refer to
the owner's information manual provided with this appliance.
For assistance or additional information consult a qualified
installer, service agency or the gas supplier.
WARNING
Do NOT use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system and
any gas control which has been under water.
B. Controls
FAN SPEED: This knob controls the speed of the blower
that pushes the heated air into the room.
MAIN BURNER: This control is used to turn the appliance
on and off.
PILOT IGNITOR: The pilot ignitor is used only to start
the pilot. When the valve control knob is turned to the
pilot position and fully depressed press the piezo ignitor
repeatedly creating a blue spark directly next to the pilot,
igniting the pilot flame.
VALVE CONTROL: This knob is used to control gas to
the appliance and for starting the pilot. There are three
positions, ON, OFF, & PILOT. The indicator on the valve
indicates the position of the knob.
COMFORT CONTROL: This knob controls the flame height
from low ("LO") to high ("HI").
NOTE: If using a remote control wall switch, or thermostat,
the On/Off Switch must be left "OFF". Turning the On/Off
Switch to "ON" will keep the appliance on continually.