Table of Contents
Advertisement
Changing base unit PIN
The base unit's PIN is set at the factory to
"0000". If you change the PIN, please write
down your new PIN as the unit will not reveal
the PIN to you. If you forget your PIN, consult
our Customer Care Centre (page 11).
1. Press {j}.
2. Press {e} or {v} repeatedly to display
"SETTING BS".
3. Press {>}.
L "INPUT CODE" will be displayed.
4. Press {5}.
5. Enter the current 4-digit base unit PIN.
6. Enter the new 4-digit base unit PIN.
7. Enter the new 4-digit base unit PIN again to
verify.
8. Press {ih}.
Setting call restriction
You can restrict selected handset(s) from dialling
selected phone numbers. You can assign up to
10 call restriction numbers (up to 8 digits). If you
dial a restricted number, the call will not be
connected and the restricted number will flash
on the display.
1. Press {j}.
2. Press {e} or {v} repeatedly to display
"SETTING BS".
3. Press {>}.
L "INPUT CODE" will be displayed.
4. Press {6}.
5. Enter the 4-digit base unit PIN.
L The default PIN is "0000".
L All the registered handset numbers are
displayed.
L If you programmed previously, the pre-
selected handset number flashes.
6. Press the desired handset number(s).
L The selected handset number will flash.
L To cancel the selected handset number,
press the number again. The number will
stop flashing.
7. Press {>}.
8. Enter the phone number to be restricted, up
to 8 digits.
L Do not enter the same number as
programmed for the fax activation code
(feature #41, page 52).
9. Press {>} or {j}.
L To enter other numbers, repeat steps 8
and 9 (up to 10 numbers).
7. Programmable Features
10. Press {ih}.
Turning off/on call restriction
1. Press {j}.
2. Press {e} or {v} repeatedly to display
"SETTING BS".
3. Press {>}.
L "INPUT CODE" will be displayed.
4. Press {6}.
5. Enter the 4-digit base unit PIN.
L The default PIN is "0000".
6. Press the desired handset number.
L Handset numbers will be displayed.
Flashing numbers indicate call restriction
is on; non-flashing numbers indicate call
restriction is off. Press the desired
handset number to turn off/on.
7. Press {>} or {j}.
8. Press {ih}.
Cancelling a call restricted number
1. Press {j}.
2. Press {e} or {v} repeatedly to display
"SETTING BS".
3. Press {>}.
L "INPUT CODE" will be displayed.
4. Press {6}.
5. Enter the 4-digit base unit PIN.
L The default PIN is "0000".
6. Press {>} repeatedly to display the desired
call restricted number.
7. Press {C}.
8. Press {>} or {j}.
9. Press {ih}.
Resetting the handset settings that use the
base unit PIN to their default settings
The handset can be reset to the following default
settings.
Feature
Ringer mode (page
62)
Number of rings
(page 63)
Base unit PIN
Call restriction
Caller information
(page 33)
Default setting
"1"
"3"
"0000"
All clear
All clear
59
Advertisement
Table of Contents
