Table of Contents
Advertisement
TCD240E(e).book Page 64 Thursday, June 9, 2005 9:14 AM
Useful Information
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect the AC
adaptor and turn off the handset, then reconnect the AC adaptor and turn on the handset.
Initial settings
Problem
w is flashing.
The handset display is blank.
The handset will not turn on.
64
Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333
Cause & solution
L The handset is not registered to the base unit.
Register it (page 55).
L The handset is too far from the base unit. Move
closer.
L The AC adaptor is not connected. Check the
connections.
L You are using the handset or base unit in an area
with high electrical interference. Locate the handset
and base unit away from interference sources, such
as antenna and mobile phones.
L The handset is not turned on. Turn the power on
(page 14).
L Make sure that the batteries are installed correctly
(page 12).
L Fully charge the batteries (page 12).
L Clean the charge contact and charge again (page
12).
Hide quick links:
Advertisement
Table of Contents
