Banner Printing Menu - Konica Minolta BIZHUB C353P User Manual

Settings for control panel
Admin. Settings Menu
Admin. Settings
Note
If an incorrect administrator password is entered, the Admin. Settings Menu does not appear.
When the password became invalid due to an administrator authentication failure and the machine
enters the restrict operation status, restart the machine.
[PrintDataCapture] is displayed when "OFF" is specified for [EnhancedSecurity].
[HDD Settings] and [User Box Settings] are displayed when a hard disk drive is installed.
[OverwritePriority] and [HDD EncryptionSet] are displayed when the Security kit is installed.
[EncryptionPassphrase] is displayed when [User-Defined] is specified for [EncryptionSetting].
[AuthDeviceSetting] is displayed when the authentication unit and HDD are installed.
[Finisher Adjust] is displayed when the finisher is installed.

Banner Printing Menu

Note
When the Finisher FS-609 is installed, after setting Banner Printing to "ON", a message that prompts
you to remove the finisher from the machine appears.
When a print job is sent on the Print Long Paper screen, printing is performed. When the job is sent, a
message prompting you to load paper appears. Load paper of the appropriate size.
To return to the original state, press the [Cancel] key on the Banner Printing screen, and then select
"Yes" for [quite] or "No" for the [Banner Printing] menu.
bizhub C353P
Security Settings
ON
Banner Printing
OK to quit?
Stabilization
ColorRegistration
Test Pattern
Banner Printing
OFF
10
Initialize+Stabi.
StabilizationOnly
Yellow
Magenta
Cyan
Gradation Pattern
Halftone Pattern
10-13