Guide To Answering System Settings - Panasonic KX-TCD210FX Operating Instructions Manual

TCD210220FX(e-e).book Page 48 Tuesday, January 18, 2005 9:04 AM
Answering System Features (KX-TCD220 only)
L You can hang up, or enter your remote
access code again and begin remote
operation.
Guide to answering
system settings
If the base unit is reset to its default settings
(page 33), the following answering system-
related settings will be reset.
Answering Default
system setting setting
Answering
Answer On
system on/off
Remote access
code
Number of
4 Rings
rings
Caller's
3 Minutes
recording time
Call screening
On
Message alert
Off
Changing the number of rings
You can change the number of times the
phone rings before the unit answers calls.
You can select 2 to 7 rings, or "Auto".
"Auto": The unit answers after 2 rings when
new messages have been recorded, and
after 5 rings when there are no new
messages. If you call your phone from
outside to listen to new messages (page
46), you will know that there are no
messages when the phone rings for the 3rd
time. You can then hang up without being
charged for the call.
1
Press {j/OK}.
2
Select "Answer System", then press
{>}.
48
3
4
5
6
Selecting the caller's recording
time
You can change the maximum message
recording time allotted to each caller, or set
the unit to greet callers but not record
Page
messages.
1
page
43
2
— page
46
3
page
4
48
page
5
48
page
6
48
page
Turning call screening on/off
48
While a caller is leaving a message, you can
screen the call through the handset speaker.
1
2
3
4
5
6
Turning message alert on/off
This feature alerts you when new messages
have been recorded. The base unit beeps
about once a minute until you have listened
to all new messages.
Select "Settings", then press {>}.
Select "Number of Rings", then
press {>}.
Select the desired setting, then press
{>}.
Press {ih}.
Press {j/OK}.
Select "Answer System", then press
{>}.
Select "Settings", then press {>}.
Select "Recording Time", then press
{>}.
Select the desired setting, then press
{>}.
Press {ih}.
Press {j/OK}.
Select "Answer System", then press
{>}.
Select "Settings", then press {>}.
Select "Call Screening", then press
{>}.
Select "On" or "Off", then press {>}.
Press {ih}.