Ringer Setup - Panasonic KX-TCD210FX Operating Instructions Manual

TCD210220FX(e-e).book Page 30 Tuesday, January 18, 2005 9:04 AM
Base Unit Settings

Ringer setup

Ringer volume
1
Press {j/OK}.
2
Select "Base Unit Setup", then
press {>}.
3
Enter "0000" (default base unit PIN).
L If you changed the PIN, enter it (page
32).
4
Select "Ringer Setup", then press
{>}.
5
Select "Ringer Volume", then press
{>}.
6
Press {e} or {v} repeatedly to select
the desired volume.
7
Press {>}.
8
Press {ih}.
Night mode
Night mode allows you to select a block of
time during which the base unit will not ring
for outside calls. This feature is useful for
times when you do not want to be disturbed,
for example, while sleeping. Night mode can
be set independently for the handset (page
25) and the base unit.
Set the date and time beforehand (page 11).
Note:
L When the message alert feature is on and
new messages are recorded, the base
unit will beep even if the night mode
setting is on (KX-TCD220 only).
Setting the start and end time for night
mode
1
Press {j/OK}.
2
Select "Base Unit Setup", then
press {>}.
3
Enter "0000" (default base unit PIN).
30
L If you changed the PIN, enter it (page
32).
4
Select "Ringer Setup", then press
{>}.
5
Select "Night Mode", then press {>}.
6
Select "Start/End", then press {>}.
7
Enter the desired hour and minute you
wish to start this feature by selecting 2
digits for each.
L If you use 12-hour time entry, select
"AM" or "PM" by pressing {*}
repeatedly before entering the time.
8
Enter the desired hour and minute you
wish to end this feature by selecting 2
digits for each.
L If you use 12-hour time entry, select
"AM" or "PM" by pressing {*}
repeatedly before entering the time.
9
Press {j/OK}.
10
Press {ih}.
Turning night mode on/off
1
Press {j/OK}.
2
Select "Base Unit Setup", then
press {>}.
3
Enter "0000" (default base unit PIN).
L If you changed the PIN, enter it (page
32).
4
Select "Ringer Setup", then press
{>}.
5
Select "Night Mode", then press {>}.
6
Select "On/Off", then press {>}.
7
Select "On" or "Off", then press {>}.
8
Press {ih}.
Setting the ring delay for night mode
This setting allows the base unit to ring
during night mode if the caller waits long
enough. After the selected amount of time
passes, the base unit will ring, useful when
someone urgently needs to speak with you.