Battery Replacement; Turning The Power On/Off; Setting The Date And Time - Panasonic KX-TCD210FX Operating Instructions Manual

TCD210220FX(e-e).book Page 11 Tuesday, January 18, 2005 9:04 AM
L If the handset is turned off, it will be turned
on automatically when it is placed on the
base unit.
Battery life
After your Panasonic batteries are fully
charged, you can expect the following
performance:
Ni-MH batteries (700 mAh)
Operation
While in use (talking)
While not in use
(standby)
Note:
L Actual battery performance depends on a
combination of how often the handset is in
use (talking) and how often it is not in use
(standby).
L Battery operating time may be shortened
over time depending on usage conditions
and ambient temperature.

Battery replacement

If 7 flashes even after the handset
batteries have been charged for 7 hours, the
batteries must be replaced.
Important:
L We recommend the use of Panasonic
rechargeable batteries noted on page 6. If
you install non-rechargeable batteries and
start charging, the batteries may leak
electrolyte.
L Do not mix old and new batteries.
1
Operating time
20 hours max.
2
170 hours max.

Turning the power on/off

Power on
Press {ih} for about 1 second.
L The display will change to the standby
Power off
Press {ih} for about 2 seconds.
L The display will go blank.

Setting the date and time

Important:
L Confirm that the AC adaptor is connected.
L Ensure that w is not flashing.
1
2
3
4
Press the notch on the handset cover
firmly and slide it in the direction of the
arrow.
Remove the old batteries positive (S)
terminal first and install the new ones.
See page 10 for battery installation.
mode.
Press {j/OK}.
Select "Handset Setup", then press
{>}.
Select "Time Settings", then press
{>}.
Select "Set Date & Time", then press
{>}.
Preparation
11