Guide To Answering System Settings - Panasonic KX-TCD820FX Operating Instructions Manual

TCD820FX(e-e).book Page 55 Tuesday, September 13, 2005 9:10 AM
Key Remote command
Erase greeting message
{*}{6}
(during greeting
message playback)
End remote operation
{*}{#}
(or hang up)
*1 If pressed within the first 5 seconds of
a message, the previous message will
be played.
Remote room monitoring
This feature allows you to listen in on a room
where another handset is located, allowing
you to monitor the sound in a room while out
of the house. To use this feature, set the
privacy feature to "Off" (page 35).
L While you are operating with remote
commands:
{3} i Press {#} and enter the desired
handset number within 10 seconds after
the long beep.
L When finished, press {9} or hang up.
Turning on the answering system
remotely
If the answering system is off, you can turn it
on remotely.
1
Dial your phone number from a touch
tone phone.
2
Let the phone ring 9 times.
L A long beep will be heard.
3
Enter your remote access code within 10
seconds after the long beep.
L The greeting message is played back.
L You can hang up, or enter your remote
access code again and begin remote
operation.
Answering System Features
l
Guide to answering
system settings
If the base unit is reset to its default settings
(page 41), the following answering system-
related settings will be reset.
Answering Default
system setting
setting
Answering Answer on
system on/off
Remote
access code
Number of
4 Rings
rings
Caller's
3 Minutes
recording time
Call screening
On
Message alert
Off
Changing the number of rings
You can change the number of times the
phone rings before the unit answers calls.
You can select 2 to 6 rings, or "Auto".
"Auto": The unit answers after 2 rings when
new messages have been recorded, and
after 5 rings when there are no new
messages. If you call your phone from
outside to listen to new messages (page
54), you will know that there are no new
messages when the phone rings for the 3rd
time. You can then hang up without being
charged for the call.
1
" (centre of joystick) i l i #
2
"Settings" i #
3
"Number of Rings" i #
4
Select the desired setting. i # i
{ih}
Page
page
51
— page
54
page
55
page
56
page
56
page
56
55