Maintenance
Emptying the waste containers
If the hole-punch waste container in punch kit installed on finisher becomes
full, the message shown below appears (if it can be emptied by the user).
Note
When the message "Punch Scrap Full Call Service." appears, contact the
service representative.
The setting for the message contents for emptying the hole-punch waste
container must be specified by the service representative. For details,
contact the service representative.
!
Detail
If the hole-punch waste container becomes full, printing cannot be
performed with a Punch setting. To continue printing, empty the hole-
punch waste container or cancel the Punch setting.
bizhub C252P
8
8-7