The 3D Cutting Mode; Removing The Cutter - Roland EGX-20 User Manual

EGX-20 USER'S MANUAL

4 The 3D Cutting mode

To cut thick material and produce a relief or the like, the EGX-20 must be in the 3D Cutting mode.
To enable the 3D Cutting mode, first detach the depth regulator unit from the spindle unit.

Removing the Cutter

If a cutter is installed, then remove the cutter first.
Open the cover for the carriage.
1
Use the included hexagonal screwdriver to loosen the
2
retaining screw for the cutter holder.
The screw is attached to the cutter holder in
such a way that it can be loosened but not
detached completely.
Grasp the top of the cutter and pull it up and out.
3
28