Roland EGX-20 User Manual page 20

EGX-20 USER'S MANUAL
Insert the cutter into the hole in the cutter holder, then
6
slowly lower the cutter.
Lower until the cutter touches the plate.
Before you install a cutter, install the cutter holder.
NOTICE
See --> p. 11 "Installing the Cutter Holder"
Use the included hexagonal screwdriver to tighten the
7
retaining screw for the cutter holder.
Tighten secure so that the cutter does not come loose
during engraving.
Press the Origin Set button on the switch panel.
8
The spindle unit rises 0.5 mm and the Origin Set light
goes dark.
18