Roland EGX-20 User Manual page 35

Setting the Origin Point for the Vertical and Horizontal Position
Refer to "Basic Steps for Moving the Spindle Unit" on
1
page 19 and move the spindle unit so that the cutter is
positioned above the lower left corner of the material.
Lower the spindle unit to check whether the cutter is at
the lower left corner.
If the Z-axis light on the switch panel is illuminated,
2
press and hold the center of the movement button for a
short while (0.6 second or more).
Make sure the Z-axis light is dark, then press and hold
the Origin Set button for a short while (0.3 second or
more).
(Pressing the Origin Set button lights the Origin Set
light. Make sure the light is illuminated, then release the
button. The Origin Set light goes dark.)
You can set the origin point for the vertical and horizontal position by pressing the Origin Set button when the Z-
axis light is dark.
4 The 3D Cutting mode
material
Move the cutter to this location.
33