Wireless Repeating Function - NETGEAR DGN2200v3 User Manual

The DGN2200v3 modem router is always in dual band concurrent mode, unless you turn off
one radio.If you enable the wireless repeater in either radio band, the wireless base station or
wireless repeater cannot be enabled in the other radio band. However, if you enable the
wireless base station in either radio band and use the other radio band as a wireless modem
router or wireless base station, dual band concurrent mode is not affected.
To set up a wireless network with WDS, both access points have to meet the following
conditions:
Both access points have to use the same SSID, wireless channel, and encryption mode.
•
Both access points have to be on the same LAN IP subnet. That is, all of the access point
•
LAN IP addresses are in the same network.
All LAN devices (wired and wireless computers) are configured to operate in the same
•
LAN network address range as the access points.

Wireless Repeating Function


To view or change the wireless repeater settings for the modem router:
Select Advanced > Advanced Setup > Wireless Repeating.
Enable Wireless Repeating Function (2.4 GHz b/g/n). Select this check box to use the
•
wireless repeating function.
Disable Wireless Client Association. If your modem router is the repeater, selecting
this check box means that wireless clients cannot associate with it. Only LAN client
associations are allowed.
If you are setting up a point-to-point bridge, select this check box.
-
If you want all client traffic to go through the other access point (repeater with wireless
-
client association), leave this check box cleared.
If you want all client traffic to go through the other access point (repeater with wireless
•
client association), leave this check box cleared.
Wireless Repeater. If your modem router is the repeater, select this radio button.
•
N300 Wireless ADSL2+ Modem Router DGN2200v3
Advanced Settings
93