Input Source Audio Setup - Onkyo TX-L55 Instruction Manual

Advanced Setup —Continued

Input Source Audio Setup

Setting the Audio Input Format
1
Use the INPUT SELECTOR but-
tons to select the input source
DVD V1 V2
that you want to set.
INPUT SELECTOR
TV AUX TUN
2
Press the REMOTE MODE [AMP]
button followed by the [SETUP]
AMP
TUNER
button.
3
Use the Up and Down [
buttons to select "4.Input Set,"
ENTER
and then press [ENTER].
4 Use the Up and Down buttons to
select "Audio," and then use the
Left and Right [
ENTER
select:
Auto: The assigned digital input
(page 31) has priority over the
input source's analog input. If
no digital signal is present,
the analog input is used.
Multi: The DVD multichannel input
is used.
Analog: The input source's analog
input is used even if a digital
signal is present at the
assigned digital input.
5 Press the [SETUP] button.
The setup menu closes.
Setting the Digital Input Format
Normally, the TX-L55 detects the format of digital audio
signals automatically. However, if you experience either
of the following issues when playing PCM or DTS mate-
rial, you may need to specify the format yourself:
• With PCM material, if the beginnings of tracks are cut
off, try setting the format to PCM.
• With DTS material, if noise is produced when fast for-
warding or reversing, try setting the format to DTS.
1
DVD
INPUT SELECTOR
TV
2
TUNER
]/[ ]
3
ENTER
]/[ ] buttons to
4
Use the INPUT SELECTOR but-
tons to select the input source
V1 V2
that you want to set.
AUX TUN
Press the REMOTE MODE [AMP]
button followed by the [SETUP]
AMP
button.
Use the Up and Down [
buttons to select "4. Input Set,"
and then press [ENTER].
Use the Up and Down buttons to
select "Format," and then use the
Left and Right [ ]/[
ENTER
select:
All: PCM, Dolby Digital, and DTS for-
mats are detected automatically. If no
digital signal is present, the input
source's analog input is used.
DTS: Select this option if playing DTS
sources with the All option produces
noise while the TX-L55 identifies the
signal format or when fast forward or
fast reverse is used. If the input signal is
not DTS, nothing will be output.
PCM: Select this option if playing a
CD or other PCM source with the All
option causes the tops of tracks to be
cut off. If the input signal is not PCM,
nothing will be output.
]/[ ]
] buttons to
51