Basic Setup; Speaker Setup - Onkyo TX-L55 Instruction Manual

Basic Setup

This chapter explains the basic settings you need to make
to get the TX-L55 up and running.

Speaker Setup

Speaker Detection
The TX-L55 can automatically detect which speakers
you've connected to it (front, center, surround, and sur-
round back).
ON
1
4
7
+ 10
--/---
TONE
DVD
INPUT SELECTOR
TV
DIMMER
TV
ENTER
INPUT
+
CH
DISC
-
PREV
CH
DISPLAY
PLAY MODE
AUDIO
DIRECT
REPEAT
-
TUN
TEST TONE
TEST TONE
OPEN/CLOSE
1 Press the REMOTE MODE [AMP]
AMP
button followed by the [SETUP]
TUNER
button.
2
Use the Up and Down [
buttons to select "0. SP Detect,"
ENTER
and then press [ENTER].
"SP Detect?" appears on the display.
ENTER
30
STANDBY
T V
I INPUT
+
2 3
TV CH
-
5 6
8 9
T V VOL
0
CLEAR
REMOTE
MODE
_
AMP
+
AMP
TUNER
V1 V2 DVD
AUX TUN TV
SLEEP
VOL
ENTER VOL
EXIT GUIDE
MUTING
SETUP
SP A SP B RANDOM
SUBTITLE ANGLE LAST M
DSP
STEREO SURR
A-B SEARCH MEMORY
+
TUN TUN M P MEM
LEVEL LEVEL
+
-
CH SEL
VIDEO OFF
L.NIGHT CINE FLTR
RC-577S
]/[ ]
3
Press [ENTER].
The connected speakers are detected
ENTER
automatically, and the results appear on
the display, as shown.
Y: Speaker connected.
N: No speaker connected.
Surround back speaker
Surround speakers
Center speaker
Subwoofer
Notes:
• Always use two surround speakers (left and right).
• Only connect a surround back speaker if you've
already connected two surround speakers. If no sur-
round speakers are connected, the surround back
speaker will not work.
• When this SP Detect function is used, the Speaker
Configuration settings (pages 48–49) will change
Speaker Level Calibration (Test Tone)
You can adjust the volume of each speaker so that all
speakers can be heard equally at the listening position.
• The individual speaker levels cannot be adjusted while
the TX-L55 is muted, a pair of headphones is con-
nected, or the DVD multichannel input is selected.
1
Press the REMOTE MODE [AMP]
AMP
button followed by the [TEST
TUNER
TONE] button.
The test tone is output by the front left
speaker.
TEST TONE
2
Turn up the volume so that you
can hear the test tone
sufficiently.
While each speaker outputs the test
VOL
tone, its name appears on the display, as
shown.