Register A Headset To Your Tl7810 Headset Base - AT&T TL7810 User Manual

Appendix
Adding and registering headsets

Register a headset to your TL7810 headset base

1. Make sure the battery is properly installed in
the headset (see page 9). The
slowly in red and blue to indicate the headset
is not registered.
2. Place the headset in the headset base and
allow it to charge for at least one hour before
beginning registration.
3. Remove the headset from the headset base.
Press and hold the PAIR button (about four
4.
seconds) until the MUTE light on the headset
base turns on and then release the button.
5. Return the headset to the headset base
for registration. The
in red and blue.
It takes about 60 seconds to complete the
registration process. The
the headset is registered but not fully charged, or
turns blue when it is registered and fully charged.
If the registration fails, you hear the voice
prompt "Not registered" when you press the
button on the headset, and the
headset flashes slowly in red and blue.
To reset the headset, remove it from the headset
base and try the registration process again.
NOTE: You cannot register a headset if another system headset is in use.
light flashes
light flashes quickly
light turns red when
light on the
34