To Register A Headset To The Headset Base - AT&T TL7710 User Manual

Getting started
Add and register headsets

To register a headset to the headset base

1. Make sure the battery is properly installed in
the headset (see page 9). The
slowly and alternately in red and blue to
indicate the headset is not registered.
2. Place the headset in the headset base and
allow it to charge for at least one hour before
beginning registration.
3. Remove the headset from the headset base.
Press and hold the PAIR button until the
MUTE light on the headset base turns on
(about four seconds) and then release the
button.
4. Return the headset to the headset base
for registration.
It takes about 60 seconds to complete the
registration. The light turns blue when it
is registered.
To verify the registration, press the
on the headset and check for a dial tone. If
the registration fails, you hear the voice prompt
"Not registered" and the
flashes slowly and alternately in red and blue.
To reset the headset, remove the headset from the
headset base and try the registration
process again.
NOTE: You cannot register a headset if any other system headset is in use.
light flashes
button
light on the headset
13