Register A Headset To The Synj Sb67138 Base - AT&T TL8900 User Manual

Getting started
Adding and registering headsets

Register a headset to the SynJ SB67138 base

1. Place the headset in the headset charger and
allow it to charge for at least five minutes
before beginning registration. Make sure the
headset is out of the headset charger before
you begin registration.
2. On the telephone base, press MENU/
3. Scroll down to Registration and then press
/ENTER.
MENU
4. Press
MENU
Register HS. The telephone base shows
Registering new device....
5. Place the headset into the charger. It
takes up to 60 seconds to complete the
registration. The telephone base shows
Cordless headset registered and beeps
when the registration is successful.
It takes about 60 seconds to complete the
registration process. The
the headset is registered but not fully charged,
or turns blue when it is registered and fully charged.
To verify the registration, press the
the headset and check for a dial tone. If you hear a
dial tone and the extension
telephone base, the registration was successful. If
the registration fails, you hear the voice prompt, "Not
registered" and the
slowly in red and blue.
/ENTER again to select
light on the headset flashes
ENTER
light turns red when
button on
icon appears on the
0
9
COVM
Speed dial setup
Customer support
Registration
>
Register HS
>
.
Deregistration
Registering
new device...
Cordless headset
registered
Line1 00:00:05
0