To Register A Headset To The Dect Headset Base - AT&T TL7610 User Manual

Getting started
Registering the headset

To register a headset to the DECT headset base:

1. Make sure the battery is properly installed in
the headset (see page 3). The ON/OFF light
flashes twice every five seconds to indicate the
headset is not registered.
2. Place the headset in the headset charger and
allow it to charge for at least five minutes
before beginning registration. Remove the
headset from the charger and replace the
headset back into the charger.
On the headset base, press and hold the PAIR
3.
button until the MUTE light on the headset
base turns on (about four seconds) and release
the button.
Registration may take about 30 seconds to
complete. The MUTE light on the headset base
turns off. The headset ON/OFF light turns blue
on the first headset registered. The headset
ON/OFF light turns orange on the second
headset registered.
To verify registration was successful, press the
headset ON/
OFF
If the registration is not successful, the
ON/OFF light on the headset flashes twice every
five seconds. To reset the headset, remove the
headset from the headset charger and try the
registration process again.
button and check for a dial tone.
6