Replacing The Document Processor Pad - Kyocera FS-1116MFP Operation Manual

Replacing the Document Processor Pad

OPERATION GUIDE
3
Wipe the Pad from top to bottom. Be careful
not to snag the Pick Spring.
After scanning approximately 50,000 pages through the Document Processor, the
pressure pad may be worn out and you may experience problems with document
feeding. In this case, it is highly recommended that you replace the pad with a new
one. Consult your nearest service representative or authorized service center to
order a document processor pad, and follow the procedure below to replace it.
1
Open the Left Cover.
2
Press both arms of the document processor
pad inwardly with your fingers and then pull
out the document processor pad.
3
Remove the document processor pad from the box.
4
Press both arms of the document processor pad inwardly with your finger.
5
Place the pad into the holes until it snaps
into place.
Maintenance
Pad
9-7