Kenmore 66513966K014 Installation Instructions Manual page 12

6. Attach the 4 plastic studs to the wooden panel using the 4 short
hex head (5,_61')screws provided.
NOTE: Do not drill deeper then 5/8" to keep from drilling through
panel. Pilot hole depths given are for 3A" thick panel.
4. Mark 4 pilot holes on the wooden panel using the template
provided. Predrill four pilot holes using a 3/32" drill bit. Use tape
to mark the drill bit to gauge hole depth. Drill pilot holes
approximately 5/8" into the custom panel.
Plastic studs attached
with 4 short screws
Visible side
7.
Wooden panel
assembly
ji
J
Align the studs on the custom wood panel to the keyhole slots
on the door assembly. Ensure that all 4 plastic studs are
engaged in the keyhole slots. Slide wood panel down until the
top surface of the wooden panel is flush with the top of the
door.
Align top
edges
5.
Check custom tape alignment with metal door slots; verify tape
is right-side up, and that the tape does not overhang the metal
door on the top, bottom or side interfaces. Remove the backing
from the custom tape by pulling straight down on the liner.
Align the custom tape to the keyhole slots on the metal door
(see image) and apply. Repeat steps for one side and then the
other.
NOTE: The adhesive on the tape is aggressive, so proper
alignment and attachment to the metal door needs to occur on
the first try.
8o
Drill through
these holes.
Customer-su
panel Remo_ 2 short screws
and replace with long
screws provided.
Open the door and align top edges. Predrill two pilot holes
using a 3/32" drill bit. Use tape to mark the drill bit to gauge hole
depth. Drill pilot holes approximately 11/2 '' (12.7 mm) into the
top corners of the door using hole in liner as a guide.
Customer-supplied
panel
7
1¾" Screw
edges
)rill through
these holes
12