Thermador PRD30 Installation Manual page 10

Electrical Supply
Installation of the range must be planned so that the rough-
in of the junction box for the receptacle or conduit
connection will allow maximum clearance to the rear of the
unit.
When the power supply cord or conduit is connected to the
mating receptacle or junction box cover, the combined plug/
receptacle or junction box cover/conduit connector should
protrude no more than 2" from the rear wall. See Figure 3b.
Refer to Figure 9 on page 14 for location of junction box on
unit. To minimize binding when the unit is connected to the
receptacle or junction box, orient the receptacle or conduit
connector, and slide back into position.
2" Maximu_
F
L
\
2" Maximum when
plugged in
Power Cord
& Receptacle
Junction Box
&Conduit
Figure 3b: Wall Connection
Step 3: Unpacking and Moving
the Range
CAUTION:
Proper equipment and adequate manpower
must be used in moving the range to avoid
injury, and to avoid damage to the unit or the
floor. The unit is heavy and should be handled
accordingly.
• The range has an approximate shipping weight as
shown in "Chart A". The grates, griddle plate, burner
caps, front kick panel, and oven racks must be
removed to facilitate handling. Removing the door(s) is
also recommended. (See "Step 8: Door Removal and
Reinstallation" on page 18) This will reduce the weight
as shown in "Chart A" and allow the range to pass
through 30" doorways. See Figure 2 on page 6. Do not
remove the griddle element and tray assembly.
• Remove the outer carton and packing material from the
shipping pallet. The dual fuel ranges are held to the
pallet by four (4) bolts (see Figure 4 and Figure 5). The
two front pallet bolts are accessible only after removing
the Kick Panel. The Kick Panel is removed by two
screws below the lower corners of the oven cavity.
After removing the bolts, the range must be lifted and
removed from the pallet.
Note:
Leave adhesive-backed foam layer over brushed-metal
surfaces, to protect finish from scratches, until the range is
installed in its final position.
Important:
DO NOT lift the range by the oven door's handle, as this
may damage the door hinges and cause the door to fit
incorrectly to the oven cavity.
iiiiiiiiiiiiiiiiiiiiiiiii!_i_i_i_i_i_i!i_i!i '_!ii61i_iifii_i_i_i_i_i_i_ii,!i_iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii iiiililililiiiiiii_i!iiii';ii_ii!ililiiii!ii_i_ii ii!81i;_i_i_i_ii_ii_iii_!_iiii_ii_i!_! _
,
Shipping Weight 340 Ibs. 450 Ibs. 590 Ibs.
Weight without 290 Ibs. 390 Ibs. 530 Ibs.
packing materials
Without door(s),
burner caps, front kick 220 Ibs. 300 Ibs. 400 Ibs.
panel and oven racks
English 8