Step 4: Installing Anti-Tip Device - Thermador PRO-GRAND PD304 Installation Instructions Manual

Step 4: Installing Anti-Tip Device
For all 30" and 36" ranges, an anti-tip device must be installed as per these
instructions.
E_ WARNING
RANG TIPPING HAZARD
All ranges can tip and injury can result. To
prevent accidental tipping of the range,
attach it to the floor, wall or cabinet by
installing the Anti-Tip Device supplied.
A risk of tip-over may exist if the appliance
is not installed in accordance with these
instructions.
If the range is pulled away from the wall
for cleaning, service or any other reason,
ensure that the Anti-Tip Device is prop-
erly reengaged when the range is pushed
back against the wall. In the event of
abnormal usage (such as a person stand-
ing, sitting, or leaning on an open door),
failure to take this precaution can result
in tipping of the range. Personal injury
might result from spilled hot liquids or
from the range itself.
_WARNING
ALL RANGES CAN
INJURY TO PER-
SONS COULD
RESULT
DEVICES PACKED
t WITH RANGE
SEE INSTALLATION
INSTRUCTIONS
WARNING
ELECTRICAL SHOCK HAZARD
• Use extreme caution when drilling holes
into the wall or floor. There may be
concealed electrical wires located
behind the wall or under the floor.
• Identify the electrical circuits that could
be affected by the installation of the
Anti-Tip Device, then turn off power to
these circuits.
• Failure to follow these instructions may
result in electrical shock or other per-
sonal injury.
CAUTION
PROPERTY DAMAGE
• Contact a qualified installer or contractor
to determine the proper method for drill-
ing holes through the wall or floor material
(such as ceramic tile, hardwood, etc.)
• Do not slide the range across an unpro-
tected floor.
• Failure to follow these instructions may
result in damage to wall or floor cover-
ings.
Tools Needed for Installation of Anti-Tip Device:
- Screwdriver, Phillips - Hammer
- Drill, electric or hand - Pencil or other marker
- Measuring tape or ruler
- 1/8" drill bit (wood or metal wall or floor)
- 3/16" carbide-tipped masonry drill bit (concrete or concrete block wall or floor)
- 3/16" anchors, drywall or concrete, 2 each (not required if mounting bracket is being attached to solid wood or
metal)
11