Moving 9 - Thermador PRO-GRAND PD304 Installation Instructions Manual

Step 3: Unpacking, Moving and Placing The Range
Due to the weight, a dolly with soft wheels
should be used to move this unit. The weight
must be supported uniformly across the bottom
(See Fig. 6).
After transporting the professional range by
dolly close to its final location, the range can be
tipped back and supported on the rear legs
while the dolly is carefully removed.
THE FLOOR UNDER THE LEGS
SHOULD BE PROTECTED (WOOD
STRIPS, CARPET, PANELING,
ETC.) BEFORE PUSHING THE
UNIT INTO POSITION. The anti-tip de-
vice must be installed (STEP 4), gas and
electrical connections should be made (STEPS
5 and 6), and the backguard installed (STEP 7)
before the range is placed in its final position.
For proper performance the professional
range must be level. (It is very important for
all products that have the griddle feature). The
range is leveled by adjusting the legs with a
wrench.
Fig. 6- Dolly Positioning
22-3/4"
Replace the kick panel and install the oven
door. To install door, see Page 18. Do not
install the oven door until the range is in its
final location. It is important that the two (2)
screws retaining the kick panel are secure
to prevent accidental access to hot sur-
faces.
Ensure that the burner caps are correctly
seated on the burner bases of the range's
cooktop.
Griddle Tilt Adjustment
Check the griddle adjustment by pouring two tablespoons of water on the back of the griddle plate. The
water should slowly roll into the grease tray. If not, adjust the two screws under the back of the griddle.
Start with one half turn counter clockwise (CCW) of the screws. Further adjustment should be made
by one-quarter turn until water slowly flows into the grease tray.
10