Step 3: Unpacking, Moving; And Placing The Range - Thermador PRO-GRAND PD304 Installation Instructions Manual

Step 3: Unpacking, Moving and Placing The Range
CAUTION
Proper equipment and ad-
equate manpower must be
used in moving the range
to avoid injury, and to avoid
damage to the unit or the
floor. The unit is heavy
and should be handled
accordingly.
The range has an approximate
shipping weight as shown in
Chart A. It is recommended that
the grates, griddle plate and
frame, burner caps, front kick
panel and oven racks be re-
moved to facilitate handling.
This will reduce the weight as
shown in Chart A and allow the
range to pass th rough 30" door-
ways. See Figs. 2A and 2B on
Page 6. Do not remove the
grill or griddle assemblies.
Remove the outer carton and
packing material from the ship-
ping base. The dual fuel ranges
are held to the skid by four (4)
bolts (see Fig. 4 and 5). After
removing the bolts the range
must be lifted and removed from
the skid.
Remove angle-mounting brack-
ets from range. This requires
the installer to remove two
screws holding each bracket
then remove bracket and rein-
stall screws.
Chart A 30" Range 36" Range 48" Range
Shipping Weight 335 Ibs. 444 Ibs. 584 Ibs.
Weight without 285 Ibs. 390 Ibs. 524 Ibs.
packing materials
Without door(s),
burner caps, front kick
panel and oven racks
215 Ibs. 295 Ibs. 395 Ibs.
FIG. 4 - Removal of Two Front
Shipping Bolts
FIG. 5 - Removal of Two Rear
Shipping Bolts
J
Left Re_tr
Shipping
Bolt