Table of Contents
Advertisement
SAFETY INSTRUCTIONS
Read All Instructions
Before Using the Appliance.
READ AND SAVE THESE INSTRUCTIONS.
/iX WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK,
OR INJURY TO PERSONS, OBSERVE THE
FOLLOWING:
A.
B.
C.
D.
E.
R
Installation work and electrical wiring must be
done by qualified person(s) in accordance with
all applicable codes and standards, including
fire-related construction.
Sufficient air is needed for proper combustion and
exhausting of gases through the flue (chimney) of
fuel burning equipment to prevent backdrafting.
Follow the heating equipment manufacturer's
guideline and safety standards such as those
published by the National Fire Protection
Association (NFPA), and the American Society for
Heating, Refrigeration and Air Conditioning
Engineers (ASHRAE), and the local code
authorities.
When cutting or drilling into wall or ceiling, do not
damage electrical wiring and other hidden utilities.
Ducted fans must always be vented to the
outdoors.
Always unplug or disconnect the appliance from
the power supply before servicing.
This unit is designed for indoor use only.
Use this unit only in the manner intended by the
manufacturer.
/iX WARNING
CAUTION: For general ventilating use only. Do not use
to exhaust hazardous or explosive materials and
vapors:
To reduce risk of fire and to properly exhaust air, be
sure to duct air outside. Do not vent exhaust air into
spaces within walls, ceilings, attics, crawl spaces or
garages.
TO REDUCE THE RISK OF FIRE, USE ONLY METAL
DUCT WORK.
To reduce the risk of fire or electric shock, do not use
the fan with any solid-state speed control device.
This appliance has been found to be in compliance with
UL507 Standard for Electric Fans and CAN/CSA-22.2
No. 113 Canadian Standard for Fans and Ventilators.
It is the responsibility of the owner and the installer to
determine if additional requirements or standards apply
in specific installations.
This unit is manufactured for indoor use only. Do not use
this unit outdoors.
Parts Needed
[] Tape Measure
[] Philips Head Screwdriver
[] Duct Tape
[] Ductwork (configuration varies depending on location;
See pages 4-7 for further information)
[] Additional Sheetmetal screws (as necessary for
ductwork installation)
Parts Included
[] Appliance assembly (1)
[] Sheetmetal Screws (2)
[] Wood Screws (6)
[] Counter Sink Screws (2)
[]
Hardware for brackets on vent (2)
[]
Plugs UX6 (8)
PAGE 1
Advertisement
Table of Contents
