Table of Contents
Advertisement
IMPORTANT INFORMATION'
/_XOld appliances are not worthless rubbish. Valuable raw
materials can be reclaimed by recycling old appliances.
Before disposing of your old appliance, render it unusable.
Z_You received your new appliance in a protective
shipping carton. All packaging materials are environmen-
tally friendly and recyclable. Please contribute to a better
environment by disposing of packaging materials in an
environmentally-friendly manner.
Z_The extractor hood can only be used in exhaust air
mode.
Z_Always mount the extractor hood over the center of
the hob.
/_XMinimum distance between electric hob and bottom
edge of extractor hood: 30" ram, Fig. 1.
Z_The extractor hood must not be installed over a solid
fuel cooker - a potential fire hazard (e.g. flying sparks) -
unless the cooker features a closed, non-removable
cover and all national regulations are observed.
Z_The smaller the gap between the extractor hood and
hotplates, the greater the likelihood that droplets will form
on the underside of the extractor hood.
Additional information
concerning
gas cookers:
/_XWhen installing gas hotplates, comply with the relevant
national statutory regulations.
Z_Always comply with the currently valid regulations and
installation instructions supplied by the gas appliance
manufacturer.
/_XOnly one side of the extractor hood may be installed
next to a high-sided unit or high wall. Gap at least 2".
Z_ Minimum distance on gas hotplates between the upper
edge of the grate and lower edge of the extractor hood:
30", Fig. 1.
Fig. 1
GAS
ELECTRIC
min. 30"
min. 30"
PAGE 2
Advertisement
Table of Contents
