Table of Contents
Advertisement
Step 5: INSTALLATION
7.
Remove the extractor hood. Drill the 4 lower
1/4"® fixing holes and press in the wall plugs flush
with the wall.
o
o
i
!
...............
................
.
13.
Insert the complete duct cover at an angle and
swivel to the rear.
I
.
Attach the extractor hood and screw into position
with the remaining 4 screws.
14.
Carefully pull the upper duct cover upwards and
screw the sides to the mounting bracket with
2 screws.
9.
Connect up the outlet ducting.
10.
Connect the hood to the electrical supply.
11.
Carefully remove the protective foil.
IMPORTANT.' Avoid damage to the sensitive surface.
12.
Insert the upper duct cover (slots downwards) into
the lower duct cover.
IMPORTANT.' Protect the cover panels from
scratches, for example by laying the template used
for marking the wall over the top edge of the lower
section.
15.
Unscrew the transpor-
tation protection
devices on the left
and right. The
transportation
protection
devices must
handed to the
customer for safe-keeping.
Z_ CAUTION - After removing the transportation
protection devices, follow the safety instructions and
the cleaning and care instructions regarding the
dangers of being crushed.
16.
Insert the grease filter
(refer to Operating Instructions).
If the vent system does not operate satisfactorily during
any of the above procedures, review all steps in these
Installation Instructions to ensure that nothing has been
omitted or overlooked. Also, refer to the Care & Use
Manual for additional information or call Thermador
Customer Support 1-800-735-4328.
PAGE 8
Advertisement
Table of Contents
