SAFETY INSTRUCTIONS Read All Instructions Before Using the Appliance. READ AND SAVE THESE INSTRUCTIONS. /iX WARNING /iX WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, CAUTION: For general ventilating use only. Do not use OR INJURY TO PERSONS, OBSERVE THE to exhaust hazardous or explosive materials and FOLLOWING: vapors:...
Page 3
IMPORTANT INFORMATION' Additional information /_XOld appliances are not worthless rubbish. Valuable raw materials can be reclaimed by recycling old appliances. concerning gas cookers: Before disposing of your old appliance, render it unusable. /_XWhen installing gas hotplates, comply with the relevant Z_You received your new appliance in a protective national statutory regulations.
PRIOR TO INSTALLATION Step 1' EXHAUST-AIR MODE 27/8" The exhaust air is discharged upwards through a duct or This can be achieved if combustion air can flow through directly through the outside wall into the open. non-lockable openings, e.g. in doors, windows and via the air-intake/exhaust-air wall box.
PRIOR TO INSTALLATION For optimum extractor hood efficiency: Step 2: PREPARING THE WALL [] Short, smooth duct pipe. [] The wall must be flat and perpendicular. [] As few bends in the ducting as possible. Ensure that the wall is capable of providing a firm hold for mounting screws and plugs.
Step 3: ELECTRICAL CONNECTION Step 4: INSTALL ELECTRICAL SERVICE Check your local building codes for proper method of WARNING: THIS APPLIANCE MUST BE installation. In the U.S., if there are no applicable local GROUNDED codes, this unit should be installed in accordance with the The extractor hood should only be connected to a National Electric Code ANSI/NFPA No.
Page 7
The reproduction, transmission or use of this document or its contests is not permifed without express written _uthonfy Offenders wi(I be li_bte for d_m_es All lights induding rights oe_ted by p_tent gr_nt ar re_ist?_tion of Q ufiWy mode[ or design ore reserved Copyright r_served Components Path...
Step 5: INSTALLATION This extractor hood is intended to be mounted onto the Note: Take into account any special kitchen wall. accessories that are going to be fitted. Remove the grease filter (refer to Operating 5. Screw on the upper and the two lower mounting brackets.
Page 9
Installation Instructions to ensure that nothing has been omitted or overlooked. Also, refer to the Care & Use Manual for additional information or call Thermador Customer Support 1-800-735-4328. PAGE 8...
Page 10
''XI0'' 6" 3-1/4"xl0" 0 ° ELBOW 7" & Shutter, Model # RJ310 TOTAL (of both columns)= NOTE: Fittings with model numbers stated are available through your Thermador dealer. All other fittings are available from most major hardware stores. PAGE 9...