Uart/Rs232 Trigger - Agilent Technologies InfiniiVision 5000 Series User Manual

4
Triggering

UART/RS232 Trigger

166
To trigger on a UART (Universal Asynchronous Receiver/Transmitter) signal connect the
oscilloscope to the Rx and Tx lines and set up a trigger condition. RS232 (Recommended
Standard 232) is one example of a UART protocol.
1 Press [Save/Recall]&Default Setup.
2 Press the [Label] key to switch labels on.
3 Turn on any analog or digital channels that you will be using for the UART/RS232
signals.
4 Press the [More] key in the Trigger section of the front panel. Rotate the Entry knob
until UART/RS232 is displayed in the Trigger softkey
5 Press the Settings softkey to display the UART/RS232 Trigger Menu.
Define
Define
Signal
Bus
Channels
Trigger Trigger
Setup
Base
InfiniiVision Oscilloscopes User's Guide
Currently
Trigger level
selected Rx or
or threshold
Tx channel
UART/RS232
trigger mode
Return to
previous menu