Passive Probes - Agilent Technologies InfiniiVision 5000 Series User Manual

Passive Probes

InfiniiVision Oscilloscopes User's Guide
All InfiniiVision oscilloscopes recognize passive probes such as the 10073C, 10074C and
1165A. These probes have a pin on their connector that connects to the ring around the
oscilloscope's BNC connector. Therefore, the oscilloscope will automatically set the
attenuation factor for recognized Agilent passive probes.
Passive probes that do not have a pin that connects to the ring around the BNC connector
will not be recognized by the oscilloscope, and you must set the probe attenuation factor
manually. See page 80.
The following passive probes can be used with the InfiniiVision oscilloscopes. Any
combination of passive probes can be used.
P P
ASSIVE ROBES

Passive Probes

1165A Passive probe, 10:1, 600 MHz, 1.5 m
10070C Passive probe, 1:1 20 MHz, 1.5 m
10073C Passive probe, 10:1, 500 MHz, 1.5 m
10074C Passive probe, 10:1, 150 MHz, 1.5 m
10076A Passive probe, 100:1, 4 kV, 250 MHz
N2863A Passive probe, 10:1, 300 MHz, 1.2 m
Connecting to the Device Under Test
Quantity Supported
4
4
4
4
4
4
3
73