Resetting The Base To Factory Defaults; Monitoring A Base With The Led Indicator - ShoreTel 930D User Manual

Using the Base Unit
1

Resetting the Base to Factory Defaults

To return a base to its factory defaults, follow this procedure:
1. Plug in the base and wait until the LED indicator starts flashing green.
2. Press and then hold the reset button on the back of the base for at least 10 seconds, or until the
LED indicator turns off.
The base restarts using its factory defaults.
W
ARNING
Never unplug a base or perform any type of reset on a base whose LED indicator is fast
flashing red (500 mS on/500 mS off); doing so can permanently damage the base. A fast red
flash means that firmware in the unit is being upgraded.

Monitoring a Base with the LED Indicator

The base has an LED indicator on the front that can be used to monitor the base's status. Additional
information on the base status is available using ShoreTel IP930D Manager.
LED State
Off
Two red flashes followed by flashing green (1 sec
on/1 sec off)
Winking green (800 mS on/200 mS off)
Solid green
Winking red (800 mS on/200 mS off)
Fast flashing red (500 mS on/500 mS off)
Flashing red/green (1 S red/1 S green)
Solid red
12 Base Station and Repeater User Guide
!
Resetting the Base to Factory Defaults
Description
No power.
Base is starting.
Base has started running but has not yet
synchronized to a master (multicell only).
Unit is operating normally and is synchronized
to a master.
No Ethernet.
Unit is upgrading firmware.
(Do not remove power.)
Registration enabled.
Critical error.
ShoreTel IP Phone 930D