Readying The Base For Use - ShoreTel 930D User Manual

Using the Base Unit
1

Readying the Base for Use

1. Prepare the configuration files for the base and upload them to the FTP server. See the ShoreTel
IP Phone 930D Planning and Installation Guide for instructions on how to prepare these files.
2. If the base will be wall mounted, remove the base stand from the bottom of the base by pressing
the area shown and pulling downward.
3. Plug the Ethernet cable downward into the jack and route the cable through the cable guide so the
cable exits near the bottom of the base.
W
ARNING
Do not unplug the Ethernet cable until the LED indicator stops fast flashing red (500 mS on/500
mS off); unplugging the cable while the LED indicator is fast flashing red can permanently
damage the base.
10 Base Station and Repeater User Guide
!
Readying the Base for Use
ShoreTel IP Phone 930D