Installing The Charcoal Filter - GE JVM1490 Installation Instructions Manual

Installation instructions
MOUNT THE OVEN
{continuedl
Insert 2 self'aligning screws
,_1 ,t
(¼"-28 x, ¼ ) through outer
top cabinet boles. Turn two
full turns on each screw.
screw completely.
NOTE: Use self:aligning screw, ¼"-28 x 2%", on
_K 't JVM1790 and self:aligning screws, ¼"-28 x , '/4 ,
on ._/M 1490, SCA1000, and SCA1001.
[] Tighten the outer two screws to the top of the
oven. (While tightening screws, hokt the oven
in place against the wall and the top cabinet.)
[ Install grease filters. See the Owner's Manual
packed with the oven.
iNSTALLiNG THE
CHARCOAL FILTER
[] Remove 2 screws on top of oven, j ust above the
grille panel, using a Phillips screwdriver. Remove
one screw on the leR side.
[]Open the door.
[] Remove the grille.
screws
Scre_ -
[]Insert the filter into the
sho\,vn,
oven
as
maneuvering it behind the plastic grille tmtil it fits
squarely into place. It will rest at an angle behind
the plastic grille on two side support robs and in
fiont of the right rear rob. When properly
installed, the wire mesh of the filter should be
visible fiom the fiont.
,/
[]Replace the grille and the 2 top screws.
Close the door and replace left side screw.
Insertmesh-sidedown
22