Preparation Of Top Cabinet - GE JVM1490 Installation Instructions Manual

Installation instructions
To use toggle bolts:
Spacingfor TogglesMore
-*@-@,_ ThanWall Thickness
IVl " IToggle Wings
ountmg •
" '."i Toggle .,:
Platedllii':l, }/Bolt ]l I;':.ilk
III : I_-Wall II I:1 [
Bolt End
[]Place the mounting plate against the wall and
insert the toggle wings into the boles in the wall
to mount the plate.
NOTE: Before tightening toggle bolts and wood
screw, make sure the tabs on the mounting plate
touch the bottom of the cabinet when pushed flush
against the wall and that the plate is properly
centered under the cabinet.
CAUTION: Be careflfl to avoid pinching fingers
between the back of the moundng plate and the wall.
[]Tighten all bolts. Pull the plate away from the wall
to help dghten the bolts.
_-_ USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill boles for the top support screws and
a hole large enough for the power cord to fit through.
• Read the instructions on the TOP CABINET
TEMPI ATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instructions on the
TOP CABINET TEMPLATE.
CAUTION: Wear safe b, goggles when drilling boles
in the cabinet bottom.
_-_ ADAPTING BLOWER FOR
OUTSIDE BACK EXHAUST
_ Remove the three that hold the blower
screws
plate to the oven. Slide blower plate flom under
its retaining flange. Remove and save the screw
that holds blower motor to oven.
Retaining _:_:_..._
FIange-..` ._...._.__-,____ BlowerPlate
__ e___ BlowerMotor
_-yy Screw
_ Careflflly the blower unit. The wires pull
()lit
will extend far enough to allow you to adjust
the blower unit.
EndB
EndA
[Rotate blower unit counterclockwise 180 °.
BeforeRotation
Oven
After Rotation
Oven
_ Gently the wires flom the
reInove
grooves.
Reroute the wires through grooves on other side
of the blower unit.
BeforeRerouting After Rerouting
Wires RoutedThroughRightSide Wires Routed ThroughLeft Side
16