Important Safety Instructions; Electrical Requirements - GE JVM1490 Installation Instructions Manual

Installation instructions
iMPORTANT SAFETY iNSTRUCTiONS
This product requires a three-prong grounded
out|et. The installer must perform a ground continuity
check on the power outlet box before beginning the
installation to instue that the out|et box is properly
grounded. If not properly grounded, or if the
outlet box does not meet electrical requirements
noted (under ELECTRICAl, REQUIREMENTS),
a qualified electrician should be employed to
correct any deficiencies.
i_1/[ CAUTION: For personal
safety, remove house fuse
i or open circuit breaker
before beginning installation
to avoid severe or fatal
shock injury.
w
CAUTION: For personal safety, the mounting surface
must be capable of supporting the cabinet load, in
addition to the added weight of this 63-85 pound
product, plus additional oven loads of up to 50 pounds
or a total weight of 113-135 pounds.
CAUTION: For personal safety, this product cannot
be installed in cabinet arrangements such as an island or
a peninsula. It must be mounted to BOTH a top cabinet
AND a wall.
NOTE: For easier installation and personal safety, it is
recommended that two people install this product.
IMPORTANT--PLEASE READ CAREFULLY. FOR
PERSONAL SAFETY, THIS APPLIANCE MUST BE
PROPERLY GROUNDED TO AVOID SEVERE OR
FATAL SHOCK.
The power cord of this appliance is equipped with
a three-prong (grounding)
plug which mates with
a standard three-prong
(grounding) wall receptacle
to minimize the possibility
of electric shock hazard
from this appliance.
Insure proper
ground exists
before use
You should have the wall receptacle and circuit checked
by a qualified electridan to make sure the receptade is
properly grounded.
Where a standard two-prong wall receptacle is
encountered, it is very important to have it replaced
with a properly grounded three-prong wall receptacle,
installed by a qualified electrician.
DO NOT, UNDER ANY CIRCUMSTANCES, CUT,
DEFORM, OR REMOVE ANY OF THE PRONGS
FROM THE POWER CORD. DO NOT USE WITH
AN EXTENSION CORD.
ELECTRICAL
REQUIREMENTS
Product radng is 120 volts AC, 60 Hertz, 15 amps, and
1.70 ldlowatts. This product IllUSt be connected to
a supply circuit of the proper voltage and fiequenc>
Wire size must conform to the requirements of the
National Electrical Code or the prevailing local code
for this kilowatt rating. The power supply cord and
plug should be brought to a separate 15 to 20 ampere
branch circuit single grounded outlet. The outlet box
should be located in the cabinet above the oven. The
outlet box and supply circuit should be installed by
a qualified electrician and confbrm to the National
Electrical Code or the prevailing local code.
3