Recirculating; General Information Attach Mounting Plate To Wall; Preparation Of Top Cabinet - GE JVM1490 Installation Instructions Manual

Installation instructions
RECIRCULATING
iNSTALLATiON OVERVIEW
C1. Attach Mounting Plate to Wall
C2. Prepare Top Cabinet
C3. A(0 ust Blower
C4. Mount the Oven
C5. Install Charcoal Filter (not supplied)
(Non-Vented Ductless)
ATTACH THE MOUNTING
PLATE TO THE WALL
Attach tile plate to the wall using toggle bolts. At
least one wood screw must be used to attach tile
plate to a wall stud.
[]Remove tile toggle wings f_om the bolts.
[]Insert the bolts into tile mounting plate through
the holes designated to go into drywall and
reatmch the toggle wings to ¾" onto each bolt.
To use toggle bolts:
Spacingfor Toggles
MoreThanWall
-_l_i_--Thicl<ness
Wings
Mounting
Plate
Bolt End
_ Place the mounting plate against the wall and
insert the toggle wings into tile boles in tile wall
to I'tlOllllt
the plate.
NOTE: Before tightening toggle bolts and wood
screw, make sure the robs on the mounting plate
touch the bottom of the cabinet when pushed flush
against tile wall and that tile plate is properly
centered under the cabinet.
CAUTION: Be careflfl to avoid pinching fingers
between the back of tile mounting plate and tile wall.
_ Tighten all bolts. Pull the plate away from tile wall
to help tighten tile bolts.
USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill boles for the top support screws and
a hole large enough for the power cord to fit through.
* Read the instructions on the TOP CABINET
TEMPI ATE.
* Tape it underneath the top cabinet.
o Drill the boles, fbllowing the instructions on the
TOP CABINET TEMPLATE.
CAUTION: Wear safeb_ goggles when drilling boles
in the cabinet bottom.
19