GE JVM1490 Installation Instructions Manual page 17

Installation instructions
]Roll the blower unit 90 ° so that fan blade
openings are facing out the back of the oven.
BeforeRolling
Backof
Oven
%
Locate the t_,vo"knockout" plates, on the rear
oven panel, near the top of the oven.
Using un snips, carefhlly cut tile web area f}om
the two boles side-by-side (that secure tile
knockouts to tile oven). Cut all fore webs on both
rear knockouts; this will allow the vendlauon fan
airflow to exhaust out the rear of tile oven.
CAUTION: Be sure to trim the sharp edges from
the openings after removing the knockout plates.
Oven Rear Panel
Snipall 4webs
on eachknockout
panelandremove
the metal knockouts
for rearairflow.
[]Place tile blower unit back into the opening.
EndA
CAUTION: Do not pull or stretch the blower
unit wiring. Make sure the wires are not pinched.
NOTE: The blower unit exhaust openings should
match exhaust openings on rear of oven.
[] Replace the blower plate in the same position
as befbre with the screws.
Blower PlateScrews
g g_/ Blower Plate
• i<-- / Backof Oven
_ Insert tile tabs each side of tile into damper
on
the boles at the inside rear of the adapton
l
-_-----__Exhaust
Adaptor
_ Attach tile exhaust adaptor to the _ear of the
oven by sliding it into the guides at tile top
center of tile back of tile oven.
ExhaustAdaptor
Slide exhaust
adaptorinto
guideson
ovenrear.
Damper
side up)
Backof Oven
Guides
o
Push in securely until it is in the lower locking
tabs. Take care to assure tile damper binge is
installed so that it is at tile top and that tile
damper swings f_eel>
_ Secu,e the exhaust adaptoI to tile oven with the
two bronze metal screws provided.
17