Determining Wall Plate Location - GE JVM1490 Installation Instructions Manual

Installation instructions
DETERMiNiNG WALL PLATE LOCATION UNDER YOUR CABINET
Plate position - beneath flat bottom
cabinet
Plate position - beneath framed recessed
cabinet bottom
Mounting PlateTabs
ig the CabinetBottom
':o
o,
Mounting PlateTabs
Touching the Back
Frame
II1
30" to Cool<top
Plate position - beneath recessed bottom
cabinet with front overhang
MountingPlatewith
TabsBelowCabinet
Bottomthe Same
Distanceas the Front
Overhang Depth
"-..
L
I II
30" to Cool<top
Your cabinets may have decorative trim that interferes
with the oven installation. Remove the decorative trhn
to install the oven properly and to make it level.
THE OVEN MUST BE LEVEL.
Use a level to make sure the cabinet bottom is level.
If the cabinets have a front overhang only, with no
back or side fiame, install the mounting plate down
the same distance as the front overhang depth. This
will
%
%
keep the oven level.
Measme the inside depth of the flont overhang.
Draw a horizontal line on the back wall an equal
distance below the cabinet bottom as the inside
depth of the fiont overhang.
For this t),pe of installation with fiont overhang only;
align the mounting robs with this horizontal line, not
touching the cabinet bottom as described in Step D.
9