Installing The Charcoal Filter - GE PSA1201 Installation Instructions Manual

c4
Mount the oVen
3
Insert a self-aligning screw through top-center
cabinet hole. Temporarily secure the oven by
turning the screw at least two full turns after
the threads have engaged. (It will be completely
tightened later.)
Cabinet Front
Cabinet Bottom Shelf
Self-Aligning Screw
Oven Top
4
Insert 3 self-aligning screws
( ⁄ "-28 x 2⅝") through outer
1
4
top cabinet holes. Turn two full
turns on each screw.
6 Tighten the outer two screws to the top of the
oven. (While tightening screws, hold the oven
in place against the wall and the top cabinet.)
7 Install grease filters. See the Owner's Manual
packed with the oven.
Installation Instructions
(continued)
Filler Block
This distance
can NOT
Equivalent
exceed 2" to
to Depth of
ensure proper
Cabinet Recess
installation
5
Tighten center
screw completely
(1/4" x 28 x 2⅝")
c5
InstallIng the chaRcoal
fIlteR
1 Remove 2 screws on top of oven, just above
the grille panel, using a Phillips screwdriver.
2
Open the door.
3 Remove the grille.
Grille
4
Insert the filter into the oven as shown until it fits
squarely into place. It will rest at an angle behind
the front lower tabs. When properly installed,
the wire mesh of the filter should be visible
from the front.
Charcoal filter installed
5 Replace the grille and the 2 top screws.
6 Close the door and replace left side screw.
22
Screws
Front lower tabs
Charcoal filter