Installing The Charcoal Filter - GE ZSA1201 Installation Instructions Manual

MOUNT THE OVEN
C4
3
Insert a self-aligning screw through top-center
cabinet hole. Temporarily secure the oven by
turning the screw at least two full turns after
the threads have engaged. (It will be completely
tightened later.)
Cabinet Front
Cabinet Bottom Shelf
Oven Top
4
Insert 3 self-aligning screws
(
1 4
top cabinet holes. Turn two
full turns on each screw.
6 Tighten the outer two screws to the top of the
oven. (While tightening screws, hold the oven
in place against the wall and the top cabinet.)
Install grease filters. See the Owner's
7
Manual packed with the oven.
22
Installation Instructions
(continued)
Filler Block
This
Equivalent
distance
to Depth
can NOT
exceed 2"
of Cabinet
to ensure
Recess
proper
installation
Self-Aligning Screw
5
Tighten center
screw completely
C5
INSTALLING THE CHARCOAL
FILTER
1 Remove 2 screws on top of oven, just above
the grille panel, using a Phillips screwdriver.
2
Open the door.
3 Remove the grille. Slide the grille to the left then
pull out.
Grille
4
Insert the filter into the oven as shown until it fits
squarely into place. It will rest at an angle behind
the front lower tabs. When properly installed,
the wire mesh of the filter should be visible
from the front.
Charcoal filter
Charcoal filter installed
5 Replace the grille and the 2 top screws.
6 Close the door and replace left side screw.
Screws
Front lower tabs
49-40650-5