Aligning The Wall Plate - GE JVM1490 Installation Instructions Manual

Installation instructions
ALiGNiNG THE WALL PLATE
HoleA
HoleD
CAUTION: Wear gloves
to avoid cutdng fingers on
sharp edges.
I
I
I
I
I Drawa Vertical
i_ Lineon Wall
from Centerof
TopCabinet
I
I
I
I
j
0 0 0 b
0 0
0 0 0 0 0 0 0 0 0 0 0 0 0
0 010 0 0 0 0 0 0 0
I nn
I
0
HoleD
[]Draw a vertical line on the wall at the center of die
30" wide space.
[_] Use the mounting plato as the template for the rear
wall. Place the mounting plato on the wall, maMng
sure that the robs are touching the bottom of the
cabinet or the level line drawn in Step C for cabinets
with front overhang. Line up the notch and center line
on the mounting plate to the center line on the wall.
[] While holding the mounting plate with one hand,
draw circles on the wall at holes A, B, C and D (see
illustration above/actual plate marked with arrows).
Four holes must be used for mounting.
NOTE: Holes C and D are inside area E. If neither
C nor D is in a stud, find a stud somewhere in area E
and draw a fifth circle to line up with the stud. It is
important to use at least one wood screw mounted
firmly in a stud to support the weight of the oven.
Set the mounting plate aside.
Drill holes on the circles. If there is a stud, drill a NJ'
hole for wood screws. For holes that don't line up with
a stud, drill a %" hole for toggle bolts.
NOTE: DO NOT MOUNT THE PLATE AT THIS TIME.
10