Recirculating; Attach Mounting Plate To Wall; Preparation Of Top Cabinet - GE JVM3160DFCC Installation Instructions Manual

RECIRCULATING

A
INSTALLATION OVERVIEW
A1. Attach Mounting Plate to Wall
A2. Prepare Top Cabinet
A3. Install Charcoal Filter (Supplied with AVM4160 and
JVM3160 models)
A4. Mount the microwave oven
A5. Installing/Replacing the Charcoal Filter Without
Access to Top Screws and the Unit Has Already
Been Mounted.
A1
ATTACH THE MOUNTING PLATE
TO THE WALL
Attach the plate to the wall using toggle bolts. At least
one wood screw must be used to attach the plate to
a wall stud.
1 Remove the toggle wings from the bolts.
2 Insert the bolts into the mounting plate through
the holes designated to go into drywall and reattach
the toggle wings to
3 4
:
Spacing for Toggles More
Than Wall Thickness
Toggle Wings
Mounting
Toggle
Plate
Bolt
Wall
Installation Instructions
onto each bolt.
Bolt End
3 Place the mounting plate against the wall and insert
the toggle wings into the holes in the wall to mount
the plate.
NOTE: Before tightening toggle bolts and wood screw,
make sure the tabs on the mounting plate touch the
bottom of the cabinet or the horizontal level line when
pushed flush against the wall and that the plate is
properly centered under the cabinet.
CAUTION:
the wall.
4 Tighten all bolts. Pull the plate away from the wall
to help tighten the bolts.
A2
USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP CABINET
You need to drill holes for the top support screws and
a hole large enough for the power cord to fit through.
Read the instructions on the TOP CABINET
TEMPLATE.
Tape it underneath the top cabinet.
Drill the holes, following the instructions on the TOP
CABINET TEMPLATE.
CAUTION:
13
Conven ience Cooking
Potato
Beverage
Popcorn
Cook
Defrost e Time
Reheat Weight/Tim
Timer
On/Off
Express Cook
Add
3 30 Sec.
1 2
6 Turntabl e
4 5
9 Surface
7 8 Light
Set Vent
0 Clock
Power
Level
Start
Cancel
Off Pause