Install The Range; Slide Range Into Opening; Final Check Of Anti-Tip Bracket - GE P2S975 Installation Instructions Manual

Installation instructions
iNSTALL THE RANGE
@
SLIDE RANGE iNTO OPENING
Position the range in front of the cabinet
opening.
r_ Make sure the supports which overhang
the countertop clear the countertop.
If necessary, raise the unit by lowering
the leveling legs.
[_ Push while lifting the range into the
opening, until the range is within 2"
of engaging the anti-tip bracket.
[] Remove the protective trim from the side
(if provided).
[_ Using the adjustable pliers or wrench,
carefully screw in the back leveling leg
until the overhang comes to rest on the
countertop.
Adjustable
wrench or pliers
r_ Carefully screw in the front two leveling
legs (similar to Step E) until the overhang
touches the countertop.
r_ Carefully push the range into the opening
until the countertop fully engages the
control panel. The back maintop overhang
should cover the cutout opening.
Counte_op
Make sure the edge of
the countertop fits flush
against the end of the
front control panel
SLIDE RANGE iNTO OPENING
(cont.)
r_ Plug the range cord into the receptacle.
Locate the cord in the back of the range
in a manner that it will not touch or be
moved by the drawer.
\ 4
i
Position range cord . -,.
so that there is no .....
interference with , ,J
storage drawer ..... .'
/i
\l
\ 4
i
, / / I
////I/
FINAL CHECK OF ANTI-TIP
BRACKET
Check to make sure that the rear leveling leg
is fully inserted into the Anti-Tip bracket and
that the bracket is securely installed.
11