Star Trac E-UB Owner's Manual page 18

h) Take the Adjustable Heart Rate Bar and attatch the cable from the
hole in the neck to the cable at the end of the Heart Rate mount.
Use (4) M6 x 25mm Button Head Screws and (4) M6 Washers to
mount the Heart Rate bar to the Display neck.
Place the bike on the floor in the position in which it will be used. Use
the leveling adjusters (located on the underside of the front and rear
feet) to compensate for uneven floor surfaces and to eliminate wob-
bling.
If needed, the arm rest angle may be adjusted by turning a screw
under the arm rest. Using the 3mm hex wrench, turn the screw clock-
wise to lower or counterclockwise to raise the arm rest angle. Both
arm rests should be adjusted to the same angle, slightly above level.
You have now completed assembly of your STAR TRAC E-RB RECUMBENT BIKE.
18
Rate Cables
M6 x 25mm
M6 Washers
STAR TRAC E SERIES BIKES O
Heart
Adjustment
Screw
' G
WNER S UIDE