Star Trac E-UB Owner's Manual page 17

Upright and recumbent bikes
Hide thumbs Also See for E-UB:
Table of Contents

Advertisement

c) Slide the display console neck onto the neck brackets of the
bike frame.
fingers between the console neck and the bike frame when sliding
the console into place.
d) Secure the display console to the frame with four M6 X 16 flat
head screws (two screws in front side and two screws in back
side). Using the 4mm hex wrench, tighten all four screws secure-
ly.
e) Take the front display to the bike. Attach the cables from the
neck to the front display.
Plug in the 12 pin display cable from the neck into
the front display circut board at J4.
Plug in the Heart Rate cable from the handlebars
into the HR board.
Plug the HR ground into the quick disconnect tab on
the display frame.
If you are installing STAR TRAC Entertainment, Refer to the
PVS Install guide before you perform this step. If not take the Coax
and the DC Power cables and return them back down the neck.
f) Attach front display to back by sliding the bottom of the front dis-
play under the two tabs at the base of the round bar. Press the
display against the round bar and rotate it to the back. Be careful
not to pinch any wires.
g) Secure the front display to the back with (8) m4 x 0.7 x 19mm
long Phillips Head Screws. Us a #2 Phillips head screwdriver and
tighten the screws snug to the plastic.
STAR TRAC E SERIES BIKES O
Be careful not to pinch the wires or your
'
G
WNER
S
UIDE
Ground
Quick
Disconnect
J4
2
1
Heart
Ground
Rate
Wire
Board
17

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

E-rb

Table of Contents