Advertisement
3,
IMPORTANT: You may have to adjust the "LO" setting for
each cooktop burner.
Checking for proper cooktop, bake and broil burner flames is
very important. The small inner cone should have a very
distinct blue flame 1/4" to 1/2" long. The outer cone is not as
distinct as the inner cone. LP gas flames have a slightly
yellow tip.
Refer to the "Complete Installation" section on page 12 to
complete this procedure."
;ii!_iiii
¸ i!i/i!i _ _ii_;;!!i
! 'z!i!il
ii;;!_ _!!_ ,zill ii _ i:; iil !i_:' _!! !_ _iii ¸ _ !11
Tip Over Hazard
A child or adult can tip the range and be killed.
Connect antiotip bracket to rear range foot.
Reconnect
the antiotip bracket,
if the range is moved.
Failure to follow
these instructions
can result in death
or serious
burns to children
and adults.
To Convert
Gas Pressure
Regulator
1. Ensure that the main shutoff valve is in the closed position
and the power supply cord is unplugged.
2,
A. To range
B. Manual shutoff valve "closed" position
C. Gas supply line
Remove storage drawer or warming drawer. Locate gas
pressure regulator at rear of storage or warming drawer
compartment.
NOTE: On models with a warming drawer, an access cover
must be removed from the gas pressure regulator.
A
Gas pressure
regulator
3. Remove plastic cover from gas pressure regulator cap.
4. Turn gas pressure regulator cap (marked "LP" on front of gas
pressure regulator) counterclockwise
with a wrench to
remove.
NOTE: Do not remove the spring beneath the cap.
Side
view
before
/
/
E
C
Side view after
A. Plastic cover
B. Gas pressure regulator cap with hollow end facing out
C. Gas pressure regulator cap with sofid end facing out
D. Washer
E. Gas pressure regulator cap
5. Turn the gas pressure regulator cap over and reinstall on
regulator so that the solid end faces out and letter "N" is
visible.
6. Replace plastic cover over gas pressure regulator cap.
To Convert
Standard
Surface
Burners
1. Remove burner cap.
2. Using a T20 ToPAscrewdriver, remove the burner base.
NOTE: Reinstall one of the screws through the range
cooktop to hold orifice spud holder in place while removing
and replacing orifice spuds.
3. Apply masking tape to the end of a 7 mm nut driver to help
hold the gas orifice spud in the nut driver while changing it.
Press nut driver down onto the gas orifice spud and remove
by turning it counterclockwise
and lifting out, set gas orifice
spud aside.
A. Gas pressure regulator
A. Orifice spud
B. Orifice spud holder
C. Screw
D. Spark electrode
IMPORTANT: Do not remove the gas pressure regulator.
14
Advertisement
