Trouble With The Activex Client - COMPRO IP70 User Manual

this camera is at 192.168.0.128.
Note: You can check the status of the connection by logging into your router
 maintenance  log or similar wordings in your router.
Camera Reset
After you've check through the above steps, you should be able to use the
iWizard Utility to scan for the camera which you've just installed. If none of the
above worked, please reset the camera and follow the above procedures
again.
You can reset the camera to the default state where it will use the onboard
LAN connection and get IP from the available local DHCP server. To reset the
camera, please power on the camera for 1 minute then press and hold the
reset button on the back of the camera for 10 seconds in order to reset setting
to factory default.
Once the camera had been reset, please give it 1 minute to reboot and start
the IP Camera Utility to scan for the camera.

Trouble with the ActiveX Client

Once you've highlighted the chosen camera, please click on the "Web Page"
button which should start your Internet Explorer. It will ask you for the user
name and password combination, the default is admin/admin, case sensitive.
Note: The application currently only runs under Microsoft Internet Explorer 6
or greater. It does not operate under other internet browsers in the time being.
No user interface in the browser:
This could be related to three possible causes.
a. ActiveX was not installed: Please install the ActiveX as per the
instruction on the screen. This component must be installed otherwise
you will not have access to the operating user interface.
56
IP70 IP Camera User's Manual